Assembly
The Tindie Kit is nearly fully assembled. There are just a few things to solder and screw together. If you bought a pre-programmed module, much of this will already be done for you because extra testing is done.
They will come pre-installed but can be changed to a vertical orientation.
See this page for jumper information
Attach the 3D printed module supports using 4 M3x8 self threading screws from the bottom of the board per the picture.
Carefully insert the modules. Make sure the pins are aligned and not offset by one or more pins. Use a M3x8 self threading screw to attach to the support.
Install the ESP32 module. The USB end goes on the board edge side. There are extra connectors to deal with different width modules.
