Bricked Watchy??

[trevmaz]

I inadvertently uploaded the incorrect boards firmware and have not been able to access the watch since. I have removed battery still no go. I have been able to upload some examples but it does not hard reset. Pressing the button sequence to reset does nothing....Can I reload the firmware that came with the watch, if so how do I do it....Thanks

[trevmaz]

Also my watch connects on com5..is that ok.

[Drominito]

Hi i have the same problem and can't enter the to the Bootloader nor to Firmware.
Any new's since now @trevmaz?

[blublear]

You can enter bootloader mode if GPIO 0 (up button) is low during boot. So either

1. Battery is connected - follow these steps to reset and enter bootloader mode
2. Battery not connected - Just hold down the up button, THEN plug in the USB

[texsean]

Make sure yiu arent using a usbc to usbc cable. The watch needs to be lit up before uploading. Start with a known good example like 7 segment set it for 2.0 and then lower the rate to 115k and flash it to the port that showed up.