MultiTaction

Contains new installation for the MultiTaction screen, configurations, set up an application, and references.

Installation

Hardware Installation (1st time for 1 cell)

1. Connect the PC that has MultiTaction installed to the router via Wi-Fi or Ethernet
2. Connect the MT screen to the same router via an Ethernet cable
3. Launch the screen and check its IP Address from the Auto DHCP panel and then switch it to Manual and make the IP address something out of the standard range that can be given by the auto DHCP to the connected devices (i.e., 192.168.8.225)
4. Go to External source and navigate to config.txt file under: C:\Users\multi\AppData\Roaming\MultiTouch and update the NetBridge > host = {ip address you added to the screen ie, 192.168.8.225}
5. Then Save changes
6. Start the server then the MT Showcase App

Note:

• For Points 1 and 2 above:

  Screen can be connected directly to the PC if the Ethernet is Crossover not Straight-Through

config.txt example:

config.txt

saved under: C:\Users\multi\AppData\Roaming\MultiTouch

To keep the MT screen working on a regular touchscreen or via an IP (Infra Red) Sensor you have to uncomment 
"NativeTouch {
}"

Touch Issues

if you still encounter an issue refer to Touch Troubleshooting Guide.pdf

Full Setup Guide and Multi MT installations

Setup Guide and MT Application

This will require a username and password:

• username: [email protected]
• password: Viviabdo12345

Designers and Operations

• Showcase Tutorials YT Playlist
• Canvas Tutorials