Search results

Turn Combing Off

Status: Open.

#19 In FracktalWorks/Fracktory-5;

· vjvarada opened on Mar 6, 2025

when printing in dual. the new extruder goes to the place where the previous extruder was, before starting the print.

Status: Open.

#18 In FracktalWorks/Fracktory-5;

· vjvarada opened on Mar 6, 2025

Part objects and add locating pins

Status: Open.

#17 In FracktalWorks/Fracktory-5;

· vjvarada opened on Nov 24, 2024

Spiral Z Hop/Diagonal

Status: Open.

#16 In FracktalWorks/Fracktory-5;

· vjvarada opened on Nov 24, 2024

Turn Combing mode off When Z-Hopping.

Status: Open.

#15 In FracktalWorks/Fracktory-5;

· vjvarada opened on Nov 24, 2024

Change the M190 temperature to a percentage to start heating the nozzle

Status: Open.

#14 In FracktalWorks/Fracktory-5;

· vjvarada opened on Nov 22, 2024

Save Nozzle Sizes in Gcode, to verify on print start

Status: Open.

#12 In FracktalWorks/Fracktory-5;

· vjvarada opened on Nov 22, 2024

Annealing Intent/Profile

Status: Open.

#11 In FracktalWorks/Fracktory-5;

· vjvarada opened on Nov 17, 2024

Make same material support better by lowering Z gap lesser than layer height and increasing fan speed for Bridge layer.

Status: Open.

#10 In FracktalWorks/Fracktory-5;

· vjvarada opened on Jul 11, 2024

lower nozzle temperature for first layer after raft

Status: Open.

#9 In FracktalWorks/Fracktory-5;

· vjvarada opened on Jul 11, 2024

Change Print Speed and Print Temps for Intents

Status: Open.

#7 In FracktalWorks/Fracktory-5;

· vjvarada opened on Jul 2, 2024

Limit Volumetric Flow rate for larger size nozzles trying to print at higher speeds

Status: Open.

#6 In FracktalWorks/Fracktory-5;

· vjvarada opened on Jul 2, 2024