Hi, first of all, thank you very much for sharing this comprehensive distribution system dataset. It has been extremely valuable for my research, and I truly appreciate the effort that went into making it publicly available.
While going through the OpenDSS transformer definitions, I noticed something that might be a typo regarding the center-tapped transformers (CTT). In the current model, they are defined as:
XHL = 2.4
XLT = 2.4
XHT = 1.6
However, in the OpenDSS examples I’ve seen, the typical configuration appears to have XHL = XHT, rather than XHL = XLT.
I just wanted to kindly check whether this was set intentionally, or if it might be a typo. It’s also possible that I’ve misunderstood something, so I would really appreciate any clarification.
Thanks again for your generous contribution and support to the community!
Best regards,
Junjia
Hi, first of all, thank you very much for sharing this comprehensive distribution system dataset. It has been extremely valuable for my research, and I truly appreciate the effort that went into making it publicly available.
While going through the OpenDSS transformer definitions, I noticed something that might be a typo regarding the center-tapped transformers (CTT). In the current model, they are defined as:
XHL = 2.4
XLT = 2.4
XHT = 1.6
However, in the OpenDSS examples I’ve seen, the typical configuration appears to have XHL = XHT, rather than XHL = XLT.
I just wanted to kindly check whether this was set intentionally, or if it might be a typo. It’s also possible that I’ve misunderstood something, so I would really appreciate any clarification.
Thanks again for your generous contribution and support to the community!
Best regards,
Junjia