Ender 3 S1 F4 (FW 20240126) Runout Sensor Problem (original Rundout Sensor)

[Quad2000]

Hello together,
I´m using the FW now several month and it´s very great!!!! Thank you very much for that awesome piece Software.
I only have the problem with the Runout Sensor. I read every Github conversation and I test every state (High, Low, Motion) and I always store the new settings but nothing works:

• Runout Acive: High and Low => nothing happens
• Runout Active: Motion => with filament in the sensor the Printer goes always after view seconds to "Service Position" to refill Filament; without Filament the printer prints.
• I also checked in the System the status of the filament sensor. Status changed when I fill in Filament or move it out
• Runout Distance is 10mm for my tests

Can somebody help me please? I try to solve this problem now for several hours but no solution....
Thank you very much :D

[mriscoc]

Check the wiki section on the runout sensor to see if you are waiting correctly for the runout distance to be reached.