Ender 3 S1 Firmware

[Despain73]

Good Morning,

I am sorry if this sounds dumb but, I cannot figure out how to Download the Latest firmware for my Printer. the Chip has a 103 on it.
I am new to this. I know it is old and I should have done more research before I bought it .

Thank you

[lagnat]

Go to the Releases section from the main page and scroll down. You want the one that start with Ender3S1-F1. The wiki explanation the naming conventions.

[lagnat]

Where did you get that screen firmware? Im not 100% sure but I don't think you needed to upgrade that. Which did you do first and what happened after that?

[lagnat]

That doesn't look like screen firmware to me but then again I don't have an S1 so not sure.

[Despain73]

I got it from the creality site I was trying to follow Mriscoc's instructions

#1298

[lagnat]

That says it's for an S1 Pro. Do you have the pro with a knob screen?

[Despain73]

No I have v3 s1 I heard it was for both. I messed up

[Despain73]

No I have v3 s1 I heard it was for both. I messed up

…

On Wed, Jan 29, 2025 at 6:40 PM Steve Green ***@***.***> wrote: That says it's for an S1 Pro. Do you have the pro with a knob screen? — Reply to this email directly, view it on GitHub <#1404 (reply in thread)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/BO6UWTCUK6VCYKYR2IP5RUT2NF7J7AVCNFSM6AAAAABWDCHN2CVHI2DSMVQWIX3LMV43URDJONRXK43TNFXW4Q3PNVWWK3TUHMYTEMBQGE4DIOI> . You are receiving this because you authored the thread.Message ID: ***@***.***>

[Despain73]

Thank you all for the help I was able to flash the screen, the main board seems to fail but the sd card reader is hit and miss. I am about ready to give it away and take up quilting LOL

[Despain73]

Creality has pretty much told me to pound sand as I do not have a receipt.
about ready to give it all away

[lagnat]

Don't give up just yet. What is the current status?

[Despain73]

Well they’ve blown me off thus far. I’ve been able to get it too this point.

[lagnat]

What firmware did you end up putting on the screen?

[Despain73]

[lagnat]

Try this first https://github.com/mriscoc/Ender3V2S1/wiki/How-to-update-the-display#dacai-firmware-update
Then you may have to plug away with suggestions from that other thread

[Despain73]

I will thank you. Will look tomorrow gotta hit the sack

[Despain73]

Thank you everyone I had a good day and was able to get the firmware fixed without Creality support as they wanted my proof of purchase and gave me a run around