Ender 3v2/mainboard 4.2.7/SpriteExtruder+CR-Touch

[BoomShanka99]

Hello guys,

Im having strange problem. I have updated my Ender3v2 with Sprite+CR-touch. And with original firmware from creality its nightmare so I wanted to try this Pro soft which is awesome! But not working for me. I cant even get started with homing and it goes to Kill status and I have to reset the printer by power shutdown. I have found end stop status option and there I see I have z_min in TRIGGERED status. (Also filament detector but that one I don use so I unchecked the option in filament settings so that one should be ok.)

And Im guessing that z_min in triggered mode will block the start of Home comand..

Im using this firmware version --Ender3V2-427-BLTUBL-T13-MPC-20231215--- which I found on one of the releases (and should be most relevant to my HW) as Im not yet able to compile firmware.

I have tested all conections and also i have completely dismantled and checked all features.

With original frimaware im able to print and all featurees works but I have bad print results (layer inconsistency on rounded objects--front of benchy)

Tested multiple filaments fresh unpacked.

I have checked al videos with configs and tested everything suggested so as a last resort Im on the thought that firmware I have is not compatible with my setup somehow (even if its absolutely common).

Can u please share some thoughts,advice or link to firmware which can solve my prob?

Thanks a lot in advance.

[Koky05]

Try look here:
FB Group: MRiscoC's Professional Firmware Group for Creality Ender 3D printers

[mriscoc]

I cant even get started with homing

Are you sure that your board is a 4.2.7 version? If it is, check in the Control/Info menu if you actually have the firmware in corresponding to your board version.

[BoomShanka99]

Can be closed. Working perfect. Im just selftrusting idiot. Thanks a lot for a grat job!

[mriscoc]

Thank you for your contribution!

[GeneralSnowball]

do you still have this firmware can i get a copy

[BoomShanka99]

Thank u for the great job! Best regard Ivo Melichar Azimut Telecom [~~Deleted for privacy~~]

…

On Sun 11. 2. 2024 at 5:34, Miguel Risco-Castillo ***@***.***> wrote: Thank you for your contribution! — Reply to this email directly, view it on GitHub <#1229 (reply in thread)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/BFTDT65K642QLHOKHJBMOKTYTBC5NAVCNFSM6AAAAABCKI4D3GVHI2DSMVQWIX3LMV43SRDJONRXK43TNFXW4Q3PNVWWK3TUHM4DIMZQHE2TM> . You are receiving this because you modified the open/close state.Message ID: ***@***.***>