Bed tramming wizard complaining about probe being out of bounds on front right point

[zurgeg]

When I run the tramming wizard from the toolbar, it succeeds in probing the front left point, and then goes to the front right, touches the bed, and retracts immediately. After retracting, the probe (CR Touch) turns purple, and Tramming error displays on the screen with text at the bottom saying Probe out of bounds

Does anyone know what's happening?

[uiJLKJ]

Hi, have you tried a manual tramming ? I would suggest you to take a piece of paper and then do it, your bed may be slightly out of touch for the probing. This happened to me once I had to higher the bed a little.

[zurgeg]

Just tried that, still out of bounds

[PipeyMnM]

Reset the mesh/ load it/ default it

[mriscoc]

Follow the steps here: https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides

[mriscoc]

https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides

[Livebaitdrifter]

Ive had this with a og minimus cooler, shimming the blt lower stopped it.
Today it came back after a year.
No settings will stop this error.