Modification for S32 V2.0 Board

[ZabbensX]

Hello everyone,

unfortunately I was only able to get a S32 V2.0 gateway. Does anyone happen to have any information about which resistors have to be replaced / removed there.

Thanks

[Victor-Mo]

@ZabbensX these new boards have a ESP32 onboard and not a ESP8266. Currently the iRT software is not available for the ESP32, so I am sorry to say this board cannot be used.

[ZabbensX]

@Victor-Mo Thanks for your reply.
Do you know if this is "only" an issue of porting the software to ESP32? Unfortunately, I can't find a circuit diagram for the board and therefore don't know which resistors need to be adjusted. I could try the porting if I knew which hardware adjustment is necessary.

[bbqkees]

@ZabbensX It is possible. See my wiki: https://bbqkees-electronics.nl/wiki/irt/irt-bus-modification.html#ems-interface-board-v3
The EMS interface V3 and the S32 Gateway have the same EMS circuit with the same component numbering.