Value not transmitted in wasm module

[aeroelectrolight]

Hello Dave, I found another bug,

Describe the bug
The values ​​are not transmitted by the wasm module. They are always at 0

To Reproduce
I tested sending a value with a custom event "1 (>K:RUDDER_TRIM_SET)". It works but the value is not transmitted. It appears in MSFS as 0.

Screenshots

I also tested with the event (>K:ELEVATOR_TRIM_SET) and different values ​​but MSFS always returns the value to 0.

Thank you so much
Regards
Ludo

[BitsAndDroids]

This may be a conflicting message that the connector prints. The value 0 is sent from your controller (i.e., event 9075 with no value would lead to the message value 0). It then triggers the command associated with ID 9075 without any additional parameters (hence the 0). Since the parameter 1 is baked in the command, it should trigger the event with 1. But now I'm typing this I'm not 100% sure that it doesn't send 0 1 ..... I'll get back to you on that

[aeroelectrolight]

Indeed, there are several scenarios:

• the arduino just sends the event id -> 9075
• the arduino sends the event id + a value (parameter 0) -> 9075 22
• the arduino sends the event id + 2 values ​​(parameter 0 and parameter 1) -> 9075 22 1
  but there would be more complex cases:
• the arduino sends the id and the parameter(s) are managed by the action formula
• the arduino sends the id and 1 of the 2 parameters, the other being managed by the action formula.

An explicit way to do this would be to put %0 and %1 to indicate in the formula that the values ​​must come from the arduino ?
Ex:

• %0 %1 (>K:ALTERNATOR_SET) in this case the arduino sending 9075 1 4
• %0 4 (>K:ALTERNATOR_SET) in this case the arduino sends 9075 1

An idea...

[aeroelectrolight]

I tested again this evening.
When the values ​​are entered in the custom event setting, like this:

It works even if the value displayed in the MSFS console is 0 like this:

But if I transmit the value as a parameter through the arduino "9075 22" with the custom event like this:

it doesn't work

I hope this helps find the problem.
Thank you very much for your work