InflatePaths: spacing between segments of output to decrease no less than the "delta"

[andrei2popa]

Hi,
I just discovered this library. Great work and thanks for sharing.
I tested "InflatePaths" on some closed paths, and I would expect the spacing between segments of output to decrease no less than the "delta", and those "chunks" to "disappear".
Or am I wrong?


Is there at least an efficient way to identify these cases in the output, I would like to skip them. I would like to avoid calculating the distances between each segment of the output.
Thank you in advance for any feedback.
Andrei

[yoavmil]

To achieve that, ex. to filter out too-thin-areas, you could offset with a larger-negative value, then offset back.
for example instead of offset(-1000), you should do offset(-1100) and then offset(+100).

I hope this answers your question.